Well Pressure Upgrades
Constant Pressure Well Systems in Western NC
A constant-pressure well system can give you steadier pressure from an existing well. Case Water Systems assesses the pump, tank, controls and available water supply before recommending compatible equipment.
Fully licensed and insured. Work is performed onsite by a licensed contractor.
Pressure swings?
Is a constant pressure system right for your house?

A constant pressure system swaps the old on-off pressure switch for a drive that speeds the pump up and down to hold the pressure steady. It’s a good upgrade in the right house, and money wasted in the wrong one.
It usually helps when:
- The shower weakens every time someone flushes or the washer fills.
- Pressure climbs and falls as the pump cycles on and off.
- The house sits well above the wellhead, with a long run up the hill.
- A bigger house, a guest house or irrigation all pull water at the same time.
It won’t help when:
- The well runs short or sputters after heavy use. A drive can’t make water the well doesn’t have. See why a well runs out of water.
- A clogged filter, a leak or a waterlogged tank is the real problem. Fix that first. See low water pressure diagnostics and pressure tank replacement.
- The pump itself is failing. See well pump replacement.
Questions to ask before you upgrade
- Will the drive work with my pump and motor? Not every pump and motor pairs with every controller. Sometimes the existing pump can stay; sometimes it can’t.
- Can the well keep up? Steady pressure lets the house use more water at once. If the well can’t supply it, you’ll find out the hard way. The plan may need storage instead, or as well.
- What size pressure tank stays in the system? Constant pressure setups still use a tank, usually a smaller one, and it still needs the right air charge.
- How is it protected from storms? A drive is electronics, and summer lightning in the mountains is hard on electronics.
- What happens if the drive fails? Ask how you get water back and how quickly parts are available.
- What warranty comes with it? New pumps and equipment we install carry the manufacturer’s warranty plus our workmanship warranty.
Where the water comes from a cistern, a holding tank or a spring, the setup is different from a conventional well. Elevation, the route to the house, space, access and freeze protection all change the design. For those systems, see booster pump systems and spring water systems.
Repairing a system that is already in place
Common problems include a controller showing a fault code, a pump that runs but delivers little water, a small pressure tank that has lost its charge, a failed pressure sensor, and pressure that drops when a storage tank runs low. Before you call:
- Write down any fault code or blinking light on the controller.
- Check the breaker. Reset it once; if it trips again, leave it off.
- Note whether it happened after a storm or a power outage.
- If water comes from a storage tank, check whether the tank is low.
We diagnose first so you know whether a part can be repaired or needs replacing, and we quote the work before it starts. See also our guide to constant pressure well system problems.
Common constant pressure questions
Will a constant pressure system fix every low-pressure problem?
No. A restricted filter, leaking line, damaged tank, faulty control or a well that cannot meet demand may need attention first. A pressure upgrade will not create water the source does not supply.
Can I keep my current well pump?
Possibly. Compatibility and condition determine whether existing equipment can be retained. We assess those factors before recommending an upgrade.
Do I need a new pressure tank?
That depends on tank condition and the proposed system requirements. Tank replacement is not assumed for every pressure upgrade.
Can you repair an existing constant pressure system?
Yes. We read any fault codes, check incoming power, the pressure sensor and the tank, and confirm the water supply before replacing parts. Many problems turn out to be a sensor, a tank or a supply issue rather than the controller or pump itself.
What warranty comes with a new constant pressure system?
You’re covered by the manufacturer’s warranty and by our workmanship warranty. Coverage depends on the equipment, so we go over it with you before the install.
How is this different from a booster pump?
A constant-pressure setup usually manages a compatible well pump with a variable-speed drive to hold steadier delivery. A booster is a separate pump that delivers water from a spring, cistern or storage tank. See booster pump systems.
Want the pressure system assessed?
Send the address, the water source, and when the pressure changes. Photos of the accessible equipment help. We’ll call or text to confirm a time. If you have no water, call (828) 222-4160.