Skip to content

Buncombe County, NC

Well, Septic and Water Treatment Service in Asheville, NC

City water covers the center of Asheville, but a short drive toward Leicester, Sandy Mush, Fairview or Barnardsville puts you on a well and septic. Case Water Systems is based in Candler, just west of town.

Fully licensed and insured. Work is performed onsite by a licensed contractor.

Need help in Asheville?

Outside the city lines: fractured rock, clay lots and what a test shows

Well pump wire reel set up during a well pump service call
A well pump wire reel set up during a service call.

Asheville sits where the Swannanoa River meets the French Broad, on red clay and weathered saprolite over gneiss and schist. Wells around the city are drilled into fractured rock, so yield depends on how many water-bearing fractures the bore crosses. A ridge-top well and a cove well a mile apart can behave very differently.

State studies covering Buncombe County found naturally occurring radon and uranium in some private wells tied to granite and gneiss. USGS describes Blue Ridge groundwater as generally soft and slightly acidic, with iron and manganese high in some wells. That is why we test before recommending a filter, a neutralizer or UV. A lab test is a separate add-on.

Homes beyond the sewer lines rely on septic, often on sloped clay lots. We do NC Level 4 real estate inspections, pump and alarm repair, drain field repair and new or replacement systems built to the Buncombe County Environmental Health permit. Need your tank pumped? Book it with us and we’ll set it up with a trusted local partner.

Before you call or buy in Asheville

  • Outside the city lines, confirm whether the house is on a well and septic, not just what the listing says.
  • Buying near Asheville? Granite and gneiss wells can carry radon or uranium, and both can be tested on request.
  • Sloped clay lots and older fields: wet spots or a sewage smell in the yard mean call.

For more warning signs around Asheville, see our well and septic service pages.

The calls we get most, and wells that still sit beside city water

A lot of our well pump repair in Asheville starts with water that sputtered, then quit, and the breaker looks fine. On a submersible system that usually comes down to the pump, the pressure switch, the control box on a three-wire pump, or a split in the line between the wellhead and the house. We work through them in that order, because a pump pull is the most expensive step and we only want to do it when the readings say the pump is the problem.

The next most common call is a pump that won’t shut off, or one that clicks on and off every few seconds. That is almost always the pressure tank. Older galvanized tanks in basements around West Asheville and Candler waterlog over time, and newer bladder tanks lose their air charge or rupture. We check the air pre-charge with the water off before we condemn a tank.

Some Asheville-area homes have city water at the street and an old well out back that still runs irrigation, a pond or a barn. If that well is still tied into the house plumbing, it needs a proper backflow arrangement. After the long city-system outage in 2024, plenty of people asked whether they could bring an abandoned well back into service.

Sometimes that works and sometimes it doesn’t. The casing, the cap, the pump and a lab test all have to check out first. We’ll tell you straight if a well isn’t worth the money.

Need a new well drilled? We can refer you to a driller we trust, then handle the pump, pressure tank and water system from there.

Leicester, Sandy Mush and the north side

Head out New Leicester Highway and the houses spread out fast. In Leicester and Sandy Mush you get older farmhouses, newer homes on cleared pasture, and a fair number of springs still in use, often with long runs to a storage tank and a booster pump. Toward Weaverville and Barnardsville the hills are steep, wells can be deep, and the drop pipe and wire get heavy.

Down in the Hominy Valley and around Enka, older homes sometimes have wells that were finished with short casing. If you see muddy water after a hard rain, the casing and wellhead are the first place we look. We also serve Candler, Fairview, Black Mountain, Arden and Swannanoa. See Buncombe County services.

Asheville questions

Do you work inside Asheville city limits?

Yes, wherever a home has a private well, spring or septic system. Most of those are on the edges of the city and out in the county.

Should I test my well near Asheville for radon or uranium?

State studies found naturally occurring radon and uranium in some Buncombe County wells, so testing is worth considering, especially when you buy. Laboratory water testing is a separate add-on, and we can help arrange it.

Do you pump septic tanks in Asheville?

We don’t pump tanks ourselves. Need your tank pumped? Book it with us and we’ll set it up with a trusted local partner. We handle the inspection, repair and install side.

Who fixes well pumps near Asheville?

Case Water Systems does. We are a licensed NC well contractor based in Candler, just west of town, and we repair and replace submersible and jet pumps, pressure tanks, switches and control boxes across Asheville and Buncombe County. We are open 24 hours for no-water calls. See well pump repair in Asheville and pressure tank replacement in Asheville.

What if my house has city water and an old well out back?

If that well is still tied into the house plumbing in any way, it needs a proper backflow arrangement so well water can’t get into the public line. We can check how it is plumbed and either separate it or set it up the right way.

Need help in Asheville?

Give us the address and what you’re seeing. We diagnose first, then price the repair before we pick up a wrench.

Ask Case Water Systems

Choose what you need help with. This guided helper can point you to the right service.

For urgent no-water problems, call us.

Call (828) 222-4160