Open 24/7
Well Pump Repair in Haywood County, NC
No water, sputtering faucets or a pump that will not shut off? We repair well pumps, tanks, switches and control boxes across Haywood County, from Waynesville and Canton to Maggie Valley.
Fully licensed and insured. Work is performed onsite by a licensed contractor.
A long climb or no water in the cove?
What a long climb does to a pump
Waynesville, Canton and Maggie Valley have town water, but the houses back in the coves run on private wells, and plenty of older places still use a spring piped downhill to a tank. What sets Haywood apart is the climb. A few hundred feet of buried line and a big rise from the well to the house is common, and that puts real strain on the pump, the check valves and the pressure tank.

A small leak on a long line can go months without anyone noticing, while the pump runs a little longer every day. If your pump seems to run more than it used to, the line is the first thing we look at. Hard starts after a storm or a lightning strike are another regular call, and so are deep wells.
Cold snaps in Maggie Valley and Cruso
Up in Maggie Valley, Cruso and the higher coves, a cold snap freezes yard hydrants, pressure switches and any line that isn’t buried deep enough. A frozen switch tube can pass for a dead pump, so we thaw and test before anyone talks about replacing it. We can also help insulate the wellhead or keep the pump house warm. More at protecting a well from freezing and low water pressure in Waynesville.
Helene sent the Pigeon River into a lot of yards. A wellhead that sat in floodwater needs inspection, disinfection and a test before the water is used again. A certified lab test can be added to our visit.
Permits, new wells and where we work
Haywood County Environmental Health in Clyde handles well and repair permits. We aren’t drillers. When a well needs replacing, we’ll connect you with a driller we trust and handle the pump, tank and wiring from there. North Carolina also requires a plate on the casing or pad after a pump installation listing the installer, the date, the intake depth and the horsepower, so the next person knows what’s down the hole.
We work in Clyde, Lake Junaluska, Jonathan Creek, Crabtree, Fines Creek, the East Fork and the back roads between. See Haywood County, well inspections in Haywood County or jet pump repair.
Common questions from Haywood County
Do you fix pumps in Waynesville and Canton?
Yes, along with Maggie Valley, Clyde, Lake Junaluska and the rest of the county. That includes submersible and jet pumps, pressure tanks, switches and control boxes.
My pump runs longer than it used to. Why?
On long uphill lines, a slow leak is a common cause. We check the line before blaming the pump.
Can a frozen switch really look like a dead pump?
Yes. We thaw it, test it and fix whatever actually failed.
Do you work on spring systems?
Yes. We check the pump, tank and line the same way we would on a drilled well.
If the water’s out, how soon can you come?
Call (828) 222-4160. It depends on the schedule, the weather and the drive into the coves.
Pump problems in Waynesville, Canton or the coves?
Send us the address and a short description of what’s wrong. We’ll get in touch to book a time. If you have no water, call (828) 222-4160.