Open 24/7
Well Pump Repair in Yancey County, NC
Below Mount Mitchell, winters at elevation go hard on lines and switches. Case Water Systems repairs well pumps, booster pumps, tanks and controls in Burnsville, Micaville, Green Mountain and across Yancey County.
Fully licensed and insured. Work is performed onsite by a licensed contractor.
Burnsville, the South Toe, or the Cane River?
Mount Mitchell weather and what it does to a water system
Yancey County is home to Mount Mitchell, the highest peak east of the Mississippi, and a lot of houses here sit on slopes that get a real winter. Past the edge of Burnsville town water, homes run on private wells. Plenty of old homeplaces on the Cane River and the South Toe still use a spring, and some have both: a well for the house and a spring for the barn or the garden, or a spring high on the hill feeding a cistern by gravity.

The most common winter call here isn’t a dead pump. It’s a frozen pressure switch tube, or a line that froze where it comes out of the ground. We check those before anything gets pulled. If the pump really has quit, we measure voltage and amp draw at the control box, look at the tank’s air charge, and then pick a replacement sized for the well and for the climb up to the house.
Wellheads, high water and the plate on your casing
When the Cane River or the South Toe gets out of its banks, wellheads close to the water can go under. North Carolina’s well construction rule says the top of the casing has to stand at least 12 inches above the ground, and a casing that has been buried by regrading or sat in floodwater is a problem. Have a flooded well inspected, disinfected and tested before anyone drinks from it. A certified lab test is something you can add to our visit; it isn’t part of the repair itself.
One thing worth looking for before you call: under the same rule, whoever installs a pump is supposed to fix a metal plate to the casing, the grout pad or the well house floor showing who installed it, the date, the depth of the pump intake and the horsepower. If yours has one, read it to us on the phone. It saves a lot of guessing.
Who handles what in Yancey County
Well permits and environmental health work go through the Toe River Health District office in Burnsville. Cistern cleaning we can usually do on the same trip. A brand new well is a job for a driller, not for us. We’ll give you the name of one we trust, and once the hole is in we set the pump, pressure tank and controls.
We work all over the county, including Burnsville, Micaville, Green Mountain, Celo, Pensacola, Bald Creek, Jacks Creek and along the Cane River. For county notes, see Yancey County. For the tank and field side of the same house, see septic services in Burnsville. The first checks to try with no water are on our main well pump repair page.
Asked by Yancey County well owners
My pump hums but no water comes out. Is it dead?
Not always. A frozen switch tube, a bad start part in the control box or a well that has run low can all look the same. We test before we pull anything.
Who handles well permits in Yancey County?
The Toe River Health District office in Burnsville.
Can you clean our cistern?
Yes, usually on the same visit, and we will look over the spring or well that fills it.
Is there a tag on my well that tells you about the pump?
There should be if the pump went in under the current state rule: a plate showing the installer, the date, the intake depth and the horsepower. Older wells often have nothing.
How soon can you come out?
Call (828) 222-4160. It depends on the schedule, the weather and how far up the hollow you are, and winter on the South Toe can slow us down.
No water in Burnsville or up the Toe?
Send the address and tell us what the faucets are doing, and we’ll call or text back with a time. Completely dry? Call (828) 222-4160.