Skip to content

When the Alarm Sounds

Septic Pump Repair in Hendersonville, NC

Hillside lots around Hendersonville, Flat Rock and Mills River often use a pump tank to reach the field. Case Water Systems repairs effluent pumps, floats and panels and tells you what failed.

Fully licensed and insured. Work is performed onsite by a licensed contractor.

A pump that will not start, or one that will not stop?

How a pumped system works on Henderson County terrain

Septic pump alarm and control panel in Western North Carolina
A septic pump alarm and control panel. On Henderson County hillside lots, a pump tank often moves effluent to the drain field.

In a pumped system, wastewater settles in the septic tank and then flows to a pump tank or chamber. Floats tell the control panel when to start and stop the effluent pump, and a separate alarm float warns of high water. The pump pushes effluent through a discharge line, usually with a check valve, to the drain field or to a pressure-dosed or drip system. For drip irrigation, timed dosing and aerobic treatment systems, see advanced septic system repair. A failure anywhere in that chain can produce the same alarm or backup, which is why we test before we replace a pump.

Henderson County runs from the Blue Ridge escarpment down toward the valley around Hendersonville and Flat Rock. On the steeper lots, the drain field is often uphill from the house, so a pump is doing regular work. Clay soils and wet weather can also keep a field from taking water as fast as the pump is sending it. Habits that are easier on the equipment: spread out laundry, fix leaking fixtures, and keep the tank on a regular pumping schedule.

If the septic alarm goes off in Hendersonville

  • Cut water use: hold off on laundry, dishes and long showers.
  • Check the breaker for the pump circuit. Reset it once; if it trips again, leave it.
  • Don’t open the pump tank or handle wiring.
  • Note whether the alarm light stays on, or comes and goes after heavy rain.

Questions to ask before a pump is replaced are on our septic pump repair page.

Repair or replace, and who handles permits

We assess the panel, the floats and the pump’s performance, and we look at discharge piping and access before we recommend a septic repair or a replacement. State rules call for an application to the county before a septic system is repaired, and in Henderson County that goes to Environmental Health in Hendersonville. We also serve Fletcher, Laurel Park and Edneyville.

Hendersonville septic pump questions

My pump seems to run constantly. What could cause that?

A hung float, a leaking check valve that lets water run back into the tank, a broken discharge line or rain leaking into the chamber can all keep a pump running. We test those before we talk about a new pump.

Will a new pump fix every septic problem?

No. A new pump will not fix a failed drain field or a tank that is full of solids. We diagnose the whole accessible system so you are not buying a pump the field cannot use.

Can you set up tank pumping too?

Yes. We set up pumping with trusted local partners, so you can book it with the same call, whether the tank has to be pumped before we can work or it is simply due.

Is a septic high-water alarm an emergency?

If sewage is backing up into the house, treat it as one and call (828) 222-4160. If the drains still work, cut water use way back and call; the pump tank has some room above the alarm float, but not much. Do not unplug the alarm.

How do I know if it is the float, the pump or the breaker?

That is what we test on site. Note whether the pump is silent, humming or running without stopping, and tell us what you see on the panel.

Need a septic pump diagnosed in Hendersonville?

Share the property address and what the pump or alarm is doing. We’ll call or text to confirm a time. If sewage is backing up, call (828) 222-4160.

Ask Case Water Systems

Choose what you need help with. This guided helper can point you to the right service.

For urgent no-water problems, call us.

Call (828) 222-4160