Skip to content

Open 24/7

Emergency Well Pump Repair in Canton, NC

No water at a Canton or Clyde home on a well? Call Case Water Systems at (828) 222-4160; we answer 24/7 and diagnose pumps, pressure switches, tanks and controls.

Fully licensed and insured. Work is performed onsite by a licensed contractor.

No water, or water that came back muddy after a flood?

The Pigeon River and what Helene left behind

Canton’s town water covers a fairly small area. Out in Clyde, Bethel and the coves off the Pigeon River, people are on wells, and a few older homes still pull from a spring. Hurricane Helene put a lot of that valley under water in 2024, and some wells there have never quite been the same.

Technician checking a well pressure tank in Western North Carolina
Checking a pressure tank on a service call. After a flood we also look hard at the well cap and wiring.

If floodwater got to your wellhead, don’t drink the water until the well has been looked at, disinfected and tested. A cap that sits in a low spot near a creek is usually the first to let muddy water in. Raising the casing above grade and sealing the cap properly fixes a lot of that for next time. Lab testing is booked on its own.

When the water just stops

Try a couple of faucets so you know the whole house is out. Go to the breaker for the well pump. If it tripped, reset it once. If it trips again, leave it alone. Look at the pressure gauge and write down the number, and check whether a whole-house filter has clogged. Don’t touch wiring that looks damaged, especially after high water.

On site, we check the power, then the switch, the tank and the control box, then the pump and the line. Nothing gets replaced until we’ve told you what failed and what it’ll take.

Afterward, and the septic side

Once the water is back, we’ll point out anything that could cause the next outage, like a short-cycling tank, a switch that has frozen before or a buried wellhead. If the well is beyond saving, drilling isn’t something we do. We’ll refer you to a driller we trust and then handle the pump, wiring and hookup ourselves.

We work on septic systems across Haywood County too. If it’s an alarm or a backup, say so when you call so we plan for it. A tank that just needs pumping can go through us as well; a local pumping company we trust does that part.

Canton and Clyde questions

Do you answer outside business hours?

Yes, at (828) 222-4160. Arrival depends on the day, the weather and the roads.

Floodwater covered my well. Can I use the water?

Not for drinking until the well has been inspected, disinfected and lab-tested. Testing is an add-on you can book with us.

Is it always the pump when the water quits?

No. A tripped breaker, a bad switch, a waterlogged tank or a clogged filter can all look like a failed pump.

Can you help with septic in Haywood County?

Yes. Tell us if it’s an alarm or a backup. If the tank needs pumping, we’ll book it through a local pumping company we trust.

What can I check before you get here?

Run more than one tap, reset the pump breaker one time, and read the pressure gauge. If the breaker won’t hold, leave it and call.

Out of water in Canton, Clyde or Bethel?

Call (828) 222-4160; that’s quicker than the form. The phone gets answered around the clock, and arrival depends on the schedule, weather and distance.

Ask Case Water Systems

Choose what you need help with. This guided helper can point you to the right service.

For urgent no-water problems, call us.

Call (828) 222-4160