Jackson County, NC
Well Pump Diagnostics in Sylva, NC
Around Sylva and Cullowhee, Case Water Systems diagnoses why a pump runs constantly, pressure cuts in and out, or water disappears after heavy use, before anyone pulls a pump.
Fully licensed and insured. Work is performed onsite by a licensed contractor.
Sylva well diagnostics
How mountain wells near Sylva behave

Wells in Jackson County draw water from fractures in hard crystalline bedrock. How much a well yields and how fast it recovers can vary widely, even between neighboring properties. Groundwater levels also change through the year, tending to be lowest in late summer and fall and recovering by late winter. A well that keeps up in spring may struggle under heavy demand in September, and that can look a lot like a failing pump.
Electrical, mechanical, pressure or supply?
Electrical problems include a tripped breaker, a failed component in the control box of a three-wire pump, damaged wiring or worn pressure-switch contacts. Mechanical problems include a worn pump, a leaking check valve that lets the pump cycle when no water is being used, or a damaged drop pipe. A waterlogged pressure tank makes the pump start and stop every few seconds.
And sometimes the water level is simply dropping faster than the well recovers during heavy use. We inspect the accessible controls, watch how the system cycles, and review any well records you have. Jackson County may hold records for wells built or repaired since July 2008. See well diagnostics.
Keep a simple log before we arrive
Write down when pressure drops or water stops, how long it takes to come back, and what was running at the time: irrigation, a tub filling, laundry or several showers. Note how often the pump seems to cycle and any breaker trips. That helps separate an equipment fault from a supply limit. If the pump is running and no water is coming out, leave it off and call (828) 222-4160.
We work with private well owners in and around Sylva, Dillsboro, Cullowhee, Webster, Tuckasegee, Balsam, Whittier and Glenville.
Common diagnostic questions in Sylva
Why does my pump turn on and off every few seconds?
Rapid cycling often points to a pressure tank that has lost its air charge, though a switch problem can contribute. See pressure tank problems.
The pump runs but no water comes out. What does that mean?
Possible causes include a low water level, a broken drop pipe or a worn pump. Leave it off if it runs continuously without delivering water and call (828) 222-4160.
My pressure is weak but the pump seems fine.
Weak delivery can come from filters, plumbing, the pressure tank or the controls, not only from the pump. See low water pressure diagnostics.
Could the well just be running short in late summer?
Yes. In Jackson County, groundwater is often lowest in late summer and fall. A well that keeps up in spring can struggle in September, which can look like a failing pump. We measure water level, flow, drawdown and recovery to tell the two apart.
What should I write down before the visit?
When the water stops or the pressure drops, how long it takes to come back, what was running at the time, how often the pump cycles and whether a breaker has tripped.
Tell us what the system is doing
Send the address, when the water or pressure changes, and a simple log of what was running if you have one.