Alarm Going Off?
Septic Alarm Repair in Highlands, NC
A septic alarm in Highlands often follows heavy rain, a pump tank in runoff, or a second home that has sat unused. Case Water Systems checks the pump, floats and control panel.
Fully licensed and insured. Work is performed onsite by a licensed contractor.
Red light, a horn, or a pump that will not quit?
Read the panel before you call

What the alarm box is doing tells us a lot before we pull into the drive. A red light and buzzer with the pump not running often points to power, a breaker, the panel or a pump that has quit. A light and buzzer with the pump humming or running nonstop can mean the pump is not moving water, or more water is coming in than it can keep up with.
An alarm that comes and goes is often a float hanging up, or the level rising after heavy use or rain and then drawing back down. No light at all, but slow drains or a wet yard over the tank, can mean the alarm itself has failed. That small detail helps us bring the right parts.
Highlands gets far more rain than the Little Tennessee valley around Franklin, and septic systems up here feel it. Many lots are steep, rocky, or both, and the tank and pump chamber often sit where water runs downhill toward them. When we find water getting in, we seal the leak at the lid, riser or joint, or we talk about replacing damaged risers.
Keeping a pumped system working on the plateau
Cut back on water until we get there, and do not open the tank or work on the wiring. We test the pump, floats and panel on site and tell you what failed before we replace anything. Need your tank pumped?
Book it with us and we’ll set it up with a trusted local partner. Second homes that are closed for the season should have the system checked before a long vacancy so a stuck pump is not waiting under the snow. Septic permits, including the application state rules require before a system is repaired, go through Macon County Public Health in Franklin.
Roads onto the plateau can slow a trip in winter or after a heavy rain, so tell us about access when you call. Arrival depends on the schedule, weather and how remote the property is.
Highlands septic alarm questions
Why is my septic alarm going off after it rained?
Highlands is one of the wettest towns in the eastern United States, and many pump tanks sit where water runs downhill toward them. If a lid or riser is not sealed, rain pours in, the pump cannot keep up and the alarm sounds. We look for those leaks on the visit.
How do I turn off my septic alarm?
If the panel has a silence button, you can use it to stop the horn. Do not unplug the alarm. The light usually stays on until the water level drops. Call (828) 222-4160 and tell us what the panel is doing.
The pump is running all the time. Is that a problem?
Yes. A pump that runs nonstop may be moving rainwater, stuck on a hung float, or unable to push water through a blocked line. It can burn the pump up. Cut back on water use and call.
Is it safe to use the toilet while the alarm is on?
Use as little water as you can until the system is checked. If wastewater is backing up, stop using the fixtures and call (828) 222-4160.
Does the county have to be involved in a repair?
North Carolina’s septic rules call for an application to the county health department before a system is repaired. In Highlands that office is Macon County Public Health in Franklin. We’ll go over it with you before work starts.
Septic alarm on in Highlands?
Tell us what the panel is doing and how we reach the property. We’ll call or text to confirm a time. If sewage is backing up, call (828) 222-4160.